Performs a wipe transition between two input clips using a growing or shrinking circle. The Wipe Percent parameter should be animated to control the transition speed. Increase the Border Width parameter to draw a border at the wipe transition edges.

In the Sapphire Transitions effects submenu.


Foreground:  The current layer.   Starts the transition with this clip.

Background:  Defaults to None.   Ends the transition with this clip. If this input is not provided, a fully transparent background is used, showing whatever is behind it.


Transition Dir:   Popup menu,  Default: Wipe Off to Bg.
Selects the direction of the transition.
Wipe Off to Bg:  transitions from the current layer to the Background.
Wipe On from Bg:  transitions from the Background to the current layer.

Auto Trans:   Popup YES-NO,  Default: No.
If enabled, a transition is performed automatically between the first and last frames of the layer. If this is off, the transition is performed manually by animating the Wipe Percent parameter.

Wipe Percent:   Default: 0,  Range: 0 to 100.
Auto Trans must be disabled for this parameter to be used. It determines the transition ratio between the From and To inputs, and would normally be animated from 0 to 100 to perform a complete transition. The curve controlling this parameter can be adjusted for more detailed control over the timing of the wipe.

Wipe Direction:   Popup menu,  Default: Circle In.
The direction of the circle wipe.
Circle In:  the circle contains the first image and shrinks inwards.
Circle Out:  the circle contains the second image and grows outwards.

Edge Softness:   Default: 0,  Range: 0 or greater.
The width of the transition edges. Larger values will cause softer, less visible edges in the wipe pattern.

Rel Width:   Default: 1,  Range: 0.1 or greater.
The relative width of the 'circle' shape. Increase to make a wider oval, decrease to make a taller one.

Rotate:   Default: 0,  Range: any.
The rotation angle of the 'circle' in degrees. This has no effect if the Rel Width parameter is 1.0.

Center:   X & Y,   Default: [360 243],  Range: any.
The location of the circle center in screen coordinates relative to the center of the frame. This parameter can be set by enabling and moving the Center Widget. Note that moving the circle center can also cause the circle size to change so that the current value of Wipe Amt remains correct.

Border Width:   Default: 0,  Range: 0 or greater.
If positive, a colored border is drawn at the wipe transition edges, using the border color, opacity, softness, and shift parameters below.

Border Color:   Default rgb: [0.75 0 0].
The color of the border. This has no effect unless Border Width is positive.

Border Opacity:   Default: 1,  Range: 0 to 1.
The opacity of the border. Decrease to make the border transparent and allow the image under it to show through. This has no effect unless Border Width is positive.

Border Softness:   Default: 0,  Range: 0 or greater.
The softness of the border edges. This has no effect unless Border Width is positive.

Border Shift:   Default: 0,  Range: any.
Shifts the border ahead of or behind the transition edge. This has no effect unless Border Width is positive.

Opacity:   Popup menu,  Default: Normal.
Determines the method used for dealing with opacity/transparency.
All Opaque:  Use this option to render slightly faster when the input image is fully opaque with no transparency (alpha=1).
Normal:  Process opacity normally.
As Premult:  Process as if the image is already in premultiplied form (colors have been scaled by opacity). This option also renders slightly faster than Normal mode, but the results will also be in premultiplied form, which is sometimes less correct.

See Also:

Sapphire Plug-ins Introduction

© 2007, GenArts, Inc. All rights reserved.